Please follow the steps below:
1) Select device
2) Insert the socket adapter at the bottom of the 48pin DIP socket with the adapter part number on the top
3) Insert the chip into the socket by following the position of pin 1 according to the instructions in the adapter information box (pin 1 facing top).
4) Enable Insertion Test and ID check under Option/Setting in the software to verify if setup is correct prior to performing any chip operation.
5) Read the master chip and save it in a Bin file by clicking file-> save
6) insert blank chip, load the saved file and run blank check.
For programmed chip, if Blank_check fails, Run Erase, Blank_Check, Program, Verify
Was this answer helpful ?
Yes
(0)
/
No
(0)
