I am having problems with the SP6100 programmer on my new Windows 7 computer, the driver is not detected and software always starts in Demo mode. Can you please help?

Please follow the steps below:

1. Remove the installed software using the control panel.
2. Download and install the software under the following link.
http://www.xeltek.com/software/sp6100/nsp6100.exe
3. Close the software.
4. Connect the programmer directly USB2.0 port of PC, and turn on the power of the
programmer.
5. Open the software.

If the problem persists, please refer to the following troubleshooting instructions:

http://www.xeltek.com/software/WindowsVista.pdf