I get overcurrent error when I try to program chips in circuit using SPIS01. What are the power limitations on the ISP01?

Updated on October 5, 2015 By admin Comments Off on I get overcurrent error when I try to program chips in circuit using SPIS01. What are the power limitations on the ISP01?

Author: admin

SPIS01 programmer can provide programming power (1.8-18V, 5W), in some cases the power provided by ISP programmer is not sufficient to make the target board work normally, (depending on customer’s target PCB requirement) . Therefore we recommend to use the self-contained power of the target board.

In the user manual, please refer to precautions for power section on page 10 http://www.xeltek.com/software/spIS01/IS01_Manual.pdf

Was this answer helpful ? Yes (0) / No (0)