Regarding programming devices onto 9000U, customer wants to select the chip and puts it in socket 1, starts programming socket 1. Then put chip in socket 2 and push start again to start programming. This is how to do the round robin programming. Is it possible?

Updated on October 10, 2015 By admin Comments Off on Regarding programming devices onto 9000U, customer wants to select the chip and puts it in socket 1, starts programming socket 1. Then put chip in socket 2 and push start again to start programming. This is how to do the round robin programming. Is it possible?

Author: admin

A : The customer can do the similar job in this way. 
1. Select the device and put it in socket 1, start programming socket 1. (Ignore the
warning message and red light on other socket)
2. Remove the chip in socket 1, insert second chip in socket 2 and start programming. 
Every time, you will need to insert one chip into the socket and program it. However, you
cannot control socket 2 while the chip in socket 1 is still working.

Was this answer helpful ? Yes (0) / No (0)